WMF STELIO Mode D'emploi page 7

Start-up
Wash the removable parts before initial use. Leave any excess power
cable which is not required in the cable compartment and insert
the cable in the notch provided. Connect the power plug to a mains
socket.
Place the juice collector and strainer on the appliance along with the
right reaming cone to fit the size of the fruit.
If using the large reaming cone, place it on the small reaming cone
with the pulp extractor. It will click into place. Then place a glass
under the pouring lip. Halve the citrus fruit and, with the cut end
facing down, place one half at a time on the reaming cone and press
down. The motor will start up automatically as the appliance has an
automatic start-stop function. The juice flows through the strainer,
which catches the pulp and pips, into the juice collector and through
the pouring lip into the glass. The machine stops operating when
the pressure is no longer applied. Repeat this process a few times to
extract as much juice as possible from the fruit. The motor may stop
working if too much pressure is applied. In this case reduce the pres-
sure. Before serving the glass of juice, close the pouring lip by taking
hold of it on both sides and pushing it upwards. If you intend to use
the juicer again after a short time, place the cover on the machine in
the interests of hygiene while it is out of use. Citrus juice should be
drunk while fresh. Under no circumstances should the juice ever be
stored in metal containers.
Cleaning and maintenance
Remove the power plug after use. It is advisable to wash the remova-
ble parts immediately after use, either with hot water and washing-up
liquid or in the dishwasher. Do not use scouring agents.
Pull the reaming cone straight up to remove it. Never immerse the
motor housing in water - just wipe the outside clean with a damp
cloth.
7