Virax 575002 VULCA VIWEL + 400 Manuel D'utilisation page 25

Fitting Code
The scan fitting code must be entered here. This contains details about the welding voltage, welding time
and (in part) cooling time and is located on the electro fusion coupler in the form of a barcode. The scan
fitting code can also be entered manually if the scan fitting code is damaged.
Traceability
If the option "Traceability of fittings" for fittings or pipes is activated in the parameters (see Section 7.5
"SETUP"), then an entry must be made at this point. This entry can be made either through use of the
barcode scanner or manually. If the "Traceability of fittings" is set as an optional entry, an entry can be
made; the query "Traceability of fittings" can also be sprung over using the > OK < button and therefore
remains empty. If the option "Traceability of fittings" is deactivated, it will not be displayed on the screen
and not queried.
Now connect the welding contacts with the fitting. Use a suitable adapter if necessary (see Section 5). The
contact surfaces of the welding plug or adapter and the fitting must be clean.
Scan in the scan fitting code with the aid of the barcode scanner. If the barcode scanner is defective or if
the scan fitting code cannot be read in, the scan fitting code can also be entered manually. To do this
press the >KEYBOARD< button (see also Section "Data entry").
If there is no cooling time integrated in the bar code of the fitting, the cooling time which is written on the
fitting can be entered manually. The user can skip this entry by pressing the >OK< button.
If there is a cooling time integrated in the bar code of the fitting, this cooling time is shown in the display
after the welding process is finished. The cooling time count down is running and the cooling time is
recorded.
If there is no cooling time integrated in the bar code of the fitting and the user has manually entered the
cooling time, this time is shown in the display after the welding process is finished. The cooling time count
down is running but the cooling time is not recorded.
Cooling time
If there is no barcode integrated in the fitting and the user has not entered manually, the cooling time is
not shown in the display and it will not be recorded.
After successful data entry the screen changes to the query concerning whether the pipes are machined
according to manufacturer's instructions. This must be confirmed with > OK <.
Before the actual welding starts the device again displays all relevant welding parameters.
Page 25