Toa WM-D5300 Série Mode D'emploi page 7

1. Power switch [On/OFF]
Power can be turned on by sliding the
power switch to the ON position, while it
can be turned off by sliding it back to the
OFF position.
2. Battery checker (green/orange/red)
Lit: Power ON
Unlit: Power OFF*
The remaining battery power is represented
by the color of the indicator.
Green: Battery power is at full charge.
Orange: Battery
started.
Red: Battery power is almost depleted,
and battery
required.
* When the battery power is depleted, the
indicator will not light up.
note
The transmitter does not transmit the signal
if the bank and channel selector switches
are set to the empty channel.
In this case, the indicator flashes red and
green alternately.
3. antenna
A transmission-type antenna.
4. Battery cover
When inserting batteries or when setting the
bank and channel, etc., the cover should be
slid in the direction of the downward arrow
( ) mark.
5. Microphone input jack
Firmly insert the input plug of the
microphone and lock it by turning the lock
knob to the right.
power depletion
replacement
6. Body clip
Convenient for when you want to attach the
unit to your belt or chest pocket.
7. Maintenance port
Not used.
note
Never open the rubber cover.
8. Battery compartment
Insert and use a dedicated rechargeable
battery or AA alkaline batteries.
has
9. encryption indicator
Lit: Encryption ON
Unlit: Encryption OFF
is
10. encryption setting switch
11. Microphone sensitivity selector switch
[H/l]
H: +10 dB
L: 0 dB
12. Bank selector switch
Make sure that the transmitter is identical
to the wireless receiver in the bank number.
13. Channel selector switch
Make sure that the transmitter is identical
to the wireless receiver in the channel
number.
14. Code setting switch [0 – 9]
15. transmission output changeover switch
[H/l]
H: 10 mW
L: 1 mW
7