Set Lock Code - JVC I'Art AV-36F802 Manuel D'instructions

Set Lock Code

Channel Guard and V-Chip settings are protected by a four-digit Lock Code. Your TV comes
pre-set with a Lock Code of "0000". You may change the code to any four-digit number you
wish. To change the Lock Code, follow the steps below.
Press the M
To SETLOCK CODE
To operate
The lock icon appears.
Press Z
ERO
LOCK CODE
The first digit will be highlighted
To select the number
To move to the next digit
Continue to follow these directions for all four numbers.
To FINISH
To save settings and exit
Your Lock Code is now set..
NOTE:
• After a power interruption you must reset the Lock Code.
• Write your Lock Code number down and keep it hidden from potential viewers.
• If you forget the Lock Code, a new code may be set using the steps listed above.
button
ENU
to access the Lock Code
0 0 0 0 0
FINISH
V-Chip
33