Threading And Feeding Welding Wire - Miller AA-40GB W/OCP LEFT W/CE Mode D'emploi

5-6. Threading And Feeding Welding Wire

ON
V
OFF
POWER
Turn on power at welding power source.
Pressure
Adjust
JOG
Push wire thru guide up to drive rolls; continue to
hold welding wire. Press power source Jog push
button until drive rolls grab wire. Adjust tension until
wire does not slip. Indicator is for reference only.
OM-242671 Page 16
Tools Needed:
Welding Power Source
PURGE
JOG
Pressure
Adjust
Press Jog push button until wire comes
out of gun. Feed wire to check drive roll
pressure. Adjust knob enough to pre-
vent slipping.
Hold wire tightly to keep it
from unraveling.
6 in.
(150 mm)
Pull and hold wire; cut off end.
WOOD
Cut off wire. Close cover.
Ref. 804 391-A / Ref. 156 798 / 802 914