Usb Connection; Changing The Battery - Selve commeo Multi Send Guide De Démarrage Rapide

GB USB-connection/Changing the battery
5. USB-connection
Via the USB connection you have the possibility to program the commeo Multi Send
via the free of charge SELVE software commeo Multi Send configuration tool.
Further information as well as the software can be found on the SELVE homepage
www.selve.de
Note: Further information as well as the software can be found on the SELVE home-
page. The USB connection can not be used to supply the commeo Multi Send with
power or to charge the batteries. Do not connect the commeo Multi Send perma-
nently to the USB as it will not go into the energy-saving mode and the batteries will
be used very quickly. Not all USB cables are suitable for data transmission and are only
USB charging cables. Entire USB charging cables can not be used for the software and
the display in the software will not switch to online.

6. Changing the battery

When the battery symbol
teries. The commeo Multi Send can still be used. When the big crossed out battery
symbol will show up, the batteries are used so that no function is no longer possible.
7. Maintenance
Clean the device with a damp cloth only. Do not use a cleansing agent since this could
damage the plastic.
will show up on the display, you should change the bat-
1. U nbolt the screw and pull of the clip.
2. Take out the batteries.
3. I nsert the new batteries (LR 03; AAA) in the
correct position.
B atteries don't belong into the domestic
garbage. Please take the batteries used
up to your local gathering point.
10