AGV AX-8 Mode D'emploi page 12

2.2) Cap Removal/Installation
1
CLICK!
2
CLICK!
4
CLICK!
3
CLICK!
12 2
To remove the cap, release the 2 press studs at the front (1)
and the 2 at the back of the helmet (2).
Remove the cap from the helmet.
N.B. Extract the cap only after releasing all the press
studs to avoid damaging them and prevent damage to the
fabric parts.
To refit the cap, insert it inside the helmet and clip the 2 press-
studs at the back (3) and the 2 buttons at the front (4) into
place.