Worx WX477 Mode D'emploi page 12

TROUBLESHOOTING
Symptom
Tool will not start when
power on
Poor cut quality
Work efficiency is low.
Blade is not clamped
tightly by the Blade Holder.
12
Jigsaw
Possible Causes
• Power cord is not plugged.
• Blade is worn out.
• Blade is assembled incorrectly
• Pushing rate is too fast.
• Blade is worn out
• Incorrect speed setting
• Incorrect Pendulum function
setting
• Blade is not inserted into
place fully.
Possible Solution
• Check to make sure power cord is
connected well into a working outlet.
• Make sure the blade is sharp and
not broken.
• Make sure the blade is installed properly.
Push the machine slowly.
• Change to a new blade.
• Adjust the variable speed control
according to the material
• Adjust the pendulum function
control according to the material
Dismantle the blade and reinstall it
correctly.
EN