Danby DTT100A1WDB Guide D'utilisation page 9

.C) Wash
1. Water Level
Set the water level properly according to the
size of the load to be washed.
2. Drain Valve selection switch
Set the drain valve selection switch on
"Wash/Rinse" position
3. Detergent
Put in the laundry detergent (If the detergent
does not dissolve easily, fill the washing
machine with a small amount of water and mix
the detergent with the water for a few minutes)
4. Clothes
Put in the clothes
(remove any matches, coins, pins, etc., that
may be in the pockets of the clothes.)
5 Water supply
Open the water tap and fill the tub to a suitable
water level for the wash load.
D) Rinse
1. Drain
Set the drain valve selector switch on DRAIN
position It takes about two minutes for the water
to drain thoroughly away.
2. Drain switch
Set the drain valve selector switch on
WASH/RINSE position again, to stop the drain
cycle
3. Water supply
Open the water tap and fill the tub to a suitable
level for the laundry
WASHING PROCEDURE
6. Wash action
Select a wash action according to the type of
fabric to be washed: Gentle, Normal
7. Wash-tub lid
Close the wash tub lid
8. Wash timer
Turn the wash timer clockwise, until you reach
the desired wash time position. The wash cycle
starts immediately.
4. Rinse-wash timer
Turn the wash timer to clockwise
Set the time to 2-4 minute position
5. Repeat processes 1 to 4 twice or three
times according to the condition of the
washed laundry.
Wash timer
8
Wash/Rinse
Soft
Drain
Heavy
Wash action