Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS FOR MODEL UTM -
People's lives depend on your safe installation of our products. It is important to follow all instruc-
tions shipped with the products. This device is to be installed by a trained electrician who is thor-
oughly familiar with the NFPA 72 National Electrical Code and will follow the NEC Guidelines as
well as state and local codes.
The selection of the mounting location for the device, its controls and the routing of the wiring is to
be accomplished under the direction of the Facilities Engineer and the Safety Engineer. In addition,
listed below are some other important safety instructions and precautions you should follow:
• Read and understand all instructions before installing or operating this equipment.
• Do not connect this unit to the system when power is on.
• Optimum sound distribution will be severely reduced if any objects are in front of the speaker. You
should ensure that the front of the speaker is clear of any obstructions.
• All effective warning speakers produce loud sounds which may cause, in certain situations, perma-
nent hearing loss. You should take appropriate precautions such as wearing hearing protection.
• After installation, ensure that all bolts and threaded joints are tightened.
• Establish a procedure to routinely check the sound system for proper activation and operation.
• Provide a copy of these instructions to the Safety Engineer, operator(s) and maintenance personnel.
• File these instructions in a safe place and refer to them when maintaining and/or reinstalling the
device.
• Consult the authority having jurisdiction in your area regarding the proper use and installation of
this product.
• After installation, test the sound system to ensure proper operation.
• All effective warning speakers produce loud sounds, which may cause, in certain situations, per-
manent hearing loss. The device should be installed far enough away from potential listeners to
limit their exposure while still maintaining its effectiveness. The OSHA Code of Federal Regula-
tions 1910.95 Noise Standard provides guidelines which may be used regarding permissible noise
exposure levels.
Failure to follow all safety precautions and instructions may result in property damage, serious in-
jury, or death to you or others.
A. General
The Federal Universal Tone Module (UTM) is a microcontroller based product capable of gen-
erating one of 32 different tones. Tone selection is accomplished by programming the 5 position
DIP Switch on the top of the module. The tones are then amplified by a SelecTone Speaker
Amplifier or SelecTone Control Unit. It can be programmed at a later time to produce a different
tone simply by changing the settings of the DIP Switch.
B. Unpacking
After unpacking the UTM, examine it carefully for possible damage that may have occurred in
transit. If the equipment has been damaged, immediately file a claim with the carrier stating the
extent of damage. Carefully check all shipping labels and tags for special instructions before
removing or destroying them.
C. Installation
UNIVERSAL TONE MODULE
SAFETY MESSAGE TO INSTALLERS
-1-
Publicité
