Flow Control - AEG 7306601 Manuel D'installation Et De Fonctionnement

FLOW CONTROL

The flow control is required for proper operation of the
Reverse Osmosis system. See Fig. 25. The flow control,
located inside the push-in elbow fitting on the drain port
of the system housing, keeps water flowing through the
membrane at the required rate. This ensures that the
system produces the best quality product water.
Periodically check the flow control to be sure the small
hole through it is clean and unrestricted.
If the flow control requires service, review the exploded
view in Fig. 25. Assemble and disassemble as shown. If
the flow control remains in the manifold when the push-in
elbow fitting is removed, you will need to remove the drain
port's collet and o-ring, as shown in the next section, to
retrieve it.
CHANGE COLLET AND O-RING
1. Remove the collet and o-ring from the fitting with a
small screwdriver. Do not scratch the internal walls of
the collet port. See Figs. 26 & 27.
2. Clean collet port, lubricate with silicone-based
lubricant, and insert the o-ring seal into the bottom of
the port. See Figs. 26 & 27.
3. Push the collet inward until it locks in place.See Figs.26
& 27.
Maintenance
1/4" (6.35 mm)
66
Flow Control
Insert
Push-in
Elbow Fitting
Red Tubing
To Drain
Push o-ring seal into
bottom of port then
follow with collet.
O-Ring
Seal
Collet
Change Collet and O-ring
Collet (Depress to
Remove Tubing)
Tubing
Disconnect Tubing
FIG. 25
Fitting
FIG. 26
FIG. 27