BH SHIATSU M1200 Instructions De Montage Et Utilisation page 30

► Step 5:
Fitting the air pipes and the electrical terminals for the armrests.
After having fitted the left and right armrests,
connect the lefthand armrest air terminals,
marked with the letters (F- G- H- I) and the
electrical terminal (AP), Fig. 5.
Next, connect the righthand armrest air terminals,
marked with the letters (F- G- H- I) and the
electrical terminal (AP), Fig.5.
► Step 6:
Fitting the leg support.-
First off, take the two sets of three and four air
pipes, marked (O- P- N) and (Q- R- S- T), out
from inside the chair, Fig.6.
Fit the seat cover which was removed in step 2,
Fig.3, using the screw that was removed
previoulsy.
Next, lift the swivel joint in the direction of the
arrow, Fig.7 and fit the legrest fastening shaft
Fig.d.
Insert the split pin Fig.f and bend the ends over as
shown in Fig.7.
30
M1200
Fig.5
Fig.6
Fig.7