OPTIONAL FRONT PELLET FEED KIT
The optional kit allows you to feed the pellet into the tank from the front side, without having to pull out the insert (a task that
requires turning the machine off ).
Before installing the device, make sure that the structure that will guard the insert has a hole with the minimum dimensions
indicated in the figure below.
The images show the minimum measures between the insert and cover and are necessary to allow you to correctly handle the
frame and remove it from its original position.
Assembly is feasible even with the insert mounted.
P70
P70H49
MINIMUM 570 X 720MM WITH OR WITHOUT OPTIONAL DRAWER
MINIMUM 570 X 720mm WITH OPTIONAL DRAWER
720
720
CAUTION:
ENSURE MAXIMUM SAFETY WHEN FOLLOWING INSTRUCTIONS!
THE STOVE MUST BE DEAD COLD, OFF AND UNPLUGGED FROM THE POWER GRID.
20