Led-Indicator - Fountain Opéra Creamy Manuel Technique

Creamy coffee:
1. Place an empty cub under the coffee outlet.
Select the button for the desired quantity (large or small)
2.
LED- indicator
Hot water
Crème coffee

LED-indicator

Red blinking: Water warming up
Green: temperature ok
Groen blinking: during coffee/water distribution cycle
Set-up*
The quantity of coffee for a large or small cup can be set as follows:
Small cup: push and hold the button until the desired quantity is in
the cup and release button. This quantity will be stored in memory
Large cup: push and hold the button until the desired quantity is in
the cup and release button. This quantity will be stored in memory
Remark: the hot water button cannot be programmed for a preset
quantity. Water will be dispensed as long as the button is pushed.
Temperature
The temperature can be set to two preset values by moving the
"tmp" jumper on the circuit board
High: install the jumper over 1 pin;
normal: install the jumper over the 2 pins.
Adjusting the coffee dose (strength of drink)
The dosage in the automatic coffee dispense section can be
adjusted.
To adjust, remove the adjuster screw (1) and use the small lever
(2) to slide the mechanism in or out so that screw hole lines up with
one of 5 holes in the mechanism. Slide the lever backwards for a
weaker drink, forwards for a stronger drink. Replace the screw
when the desired setting is reached. The system is factory set on
number 2 setting.
2
Cleaning and caring for the machine
To ensure that your Creamy always delivers the perfect drink, it is
very important that the coffee dispensing and mixing system is kept
clean.
Every day
remove the coffee outlet nozzle (1) and rinse thoroughly in hot
water
empty drip tray and rinse clean
clean drip tray cover
remove coffee cartridge from whipped coffee position, place
cup under outlet nozzle and press the LARGE CUP button. This
will flush clean water through the whipper system. Repeat if
required
Every week
remove coffee cartridge from whipped coffee position
Remove the cartridge holder (2) and slide (3) by pulling slide
forwards and lifting both parts up and towards you
Remove the steam trap (4) by turning clockwise and lifting
upwards
Carefully lift the bowl (5) and pull forwards out of the water
connector. A small amount of water may drip from the
connector
Remove the mixing chamber (6) by turning clockwise and
pulling firmly towards you
Pull the outlet nozzle (1) from the mixing chamber
Wash all parts thoroughly. Be sure to dry the steam trap and
bowl before replacing
Replace all parts in reverse order
Replace the ingredient cartridge making sure pin (7) fits
through hole on cartridge slide
The cabinet should be cleaned with a damp cloth. Do not use
any type of abrasive cleaner
7
1
2
3
4
5
6
1