Fountain Opéra Creamy Manuel Technique page 7

Opera Creamy technical Manual
These instructions are intended for use with the FOUNTAIN Opera
CREAMY drinks server
CREAMY
– Automatic dispenser of coffee in 2 cup sizes ( small & large)
– manual dispenser of drink products (3 products), , manual
dispenser of hot water
SPECIFICATION & ELECTRICAL INFORMATION*
Electrical 230Vac, 50Hz, 1000W, 4.34 A.
Size 450mm high x 405mm wide x 360mm deep
Capacity 37 cups 125 ml
Weight 8 Kg
WARNING
THIS MACHINE DISPENSES HOT WATER AT APPROX
90°C. IT IS NOT SUITABLE FOR UNSUPERVISED USE BY YOUNG
CHILDREN OR AGED OR INFIRM PERSONS
THIS MACHINE MUST BE EARTHED
THIS MACHINE IS NOT FOR USE IN COOKING AREAS
DO NOT OPERATE WITHOUT THE TANK COVER
DO NOT SWITCH ON BEFORE FILLING THE TANK WITH DRINKABLE
WATER
INSTALLATION*
Make sure that the grounding of the electrical mains to which the
machine will be connected is in good conditions and in compliance
with domestic and European standards concerning electrical safety.
The machine is equipped with a power supply cord VII-H50VV-F-
3G1.0, 3x1.5 mm2 with Shucko plug C19.
Make sure that the electrical mains voltage is the same as
indicated on the identification sticker of the machine and that
the current rating of the plug is suitable for the current absorbed by
the machine.
The identification sticker is put on the back of the machine. For
connection, an electric plug, single-phase, 230V
- 50 Hz, for a maximum load of 15 A is required.
Any type of plug, which is incompatible with the socket of the
machine, must be replaced. Do not use
adaptors or multiple plugs.
This machine should only be installed in an indoor area where the
ambient temperature range is +5 o C (41 o F) to +40
Position the machine in the desired location, close to a 220Vac,
1.
15A socket outlet
Fill the machine with water to the "MAX" water level mark
2.
inside the tank
Plug the machine into the socket outlet and switch on. Allow
3.
the water to reach operating temperature (20 – 30 minutes)
Disconnect and empty the machine. Dispense some of the
4.
water through the valve into a suitable container. This will
eliminate the chance of any odor or taste from the
manufacturing process affecting your drinks
Repeat steps 2, 3 and 4
5.
SETTING UP*
1. Decide on a position for each ingredient cartridge on the
machine
2. Set the stroke adjusters on the cartridge holders to the
recommended setting (see diagram below. Recommended
settings are shown on the cartridge)
3. Fit the ingredient cartridges to the machine
4. Fit the drip tray and drip tray cover
Stroke adjuster
5.
USING THE MACHINE*
1. Place an empty cup under the desired ingredient cartridge
2. Push rocking mechanism in until it stops, then allow it to snap
back (some drinks will require more than one push, see
cartridge for recommended dose)
3. Place cup under water outlet and press button until cup is filled
to the desired level.
4. Stir drink to ensure product is dissolved.
o C (104 o F)
5.open de frontpanel ; press lightly on the left side and turn to the
right to open.
6 place a coffee cartridge in the mixing system
Adjuster setting
Rocking
mechanism
Push
place the coffee cartridge
in the mixing system
Install the coffee cartridge
making the pin of the slide
mechanism protrude through
the hole in the cartridge
drawer