Connecting To A Dvr - Lorex Vantage LW2231 Mode D'emploi

5. Connecting to a DVR

Before powering on the receiver, make sure to first connect and
power on the camera. This will ensure a proper connection.
1
1 Connect the BNC video cable from the receiver to the video input on your DVR.
2 Connect the RCA audio cable from the receiver to the corresponding audio input. The audio
input number or name should match the video input where you connect the BNC cable (e.g.
Video Input 1 and Audio Input 1).
3 Connect the power cable to the power port on the receiver and plug it into a power outlet or
surge protector.
4 Place the receiver where it will have clear reception to your camera
NOTE: If your camera is out of range, the pairing status LED will flash on and off rapidly.
OPTIONAL: Use the double-sided tape to secure the receiver to a surface (e.g. wall).
1. Avoid installing in a location which requires the wireless signal to pass through cement, con-
crete, and metal structures. This will reduce the range of transmission.
2
Connecting to a DVR
3
1
.
7