Mounting Positions; To Install The Camera - Lorex Vantage LW2231 Mode D'emploi

4.2 Mounting Positions

You may mount your camera on a wall, ceiling, or counter. See the images below for
recommended configurations of the camera stand and antenna.
Wall
NOTE: For ceiling installation, position the antenna as high as the ceiling allows. See the
"Ceiling" mounting position in the figure above.
Before mounting the camera permanently, carefully plan where and
how the camera will be positioned and where you will route the cable
that connects the camera to the power adapter. Verify the camera's
performance by observing the image on a monitor when the camera
is positioned where it will be permanently installed.

4.3 To Install the Camera

1 Use the included mounting screws to mount the camera to the mounting surface:
• Mark the positions of the screw holes
on the mounting surface.
• Drill holes and insert the drywall plugs
(included) as needed.
• Firmly attach the camera to the
mounting surface using the included
screws.
NOTE: If you are running the power cable through the mounting surface, connect power
before firmly attaching the camera to the mounting surface.
NOTE: If you are running the power cable along the mounting surface, you need to run the
power connector cable through the cable notch on the camera base before firmly
attaching the camera to the mounting surface.
Ceiling
Cable Notch
Installing the Camera
Counter
5