Product Features - LEXIBOOK SMBABY1 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Battery installation

1. Using a screwdriver, open the battery compartment located at the back

of the parent unit.

2. Insert x AA/LR6 size batteries (not included) observing the polarity

indicated in the compartment, and as per the diagram shown opposite.

. Close the battery compartment and tighten the screw.

Note: The adapter must be disconnected from the DC IN jack on the

rear of the unit in order to let the product operate on battery power.

Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed

from the product before being charged. Rechargeable batteries are only to be charged under

adult supervision. Different types of batteries or new and used batteries are not to be mixed.

Only batteries of the same or equivalent type as recommended are to be used. Batteries are to

be inserted with the correct polarity. Exhausted batteries are to be removed from the product.

The supply terminals are not to be short circuited. Do not throw batteries into a fire. Remove the

batteries if you are not going to use the product for a long period of time.

WARNING: If the units malfunction or receive an electrostatic shock, press the RESET buttons. If

this proves to be ineffective, remove the batteries and insert them again.

Baby unit (picture A)

1. Night light

2. "Comfort Zone" button

3. "Sleep Guardian" Start/Stop button

. DC IN 6V

5. Volume button

6. "Night light" On/Off button

7. "Sleep Guardian" mode selector switch

8. "Sleep Guardian" sensitivity selector switch

9. Battery compartment

10. Baby unit table stand

11. "Baby monitor" transmission mode selector switch

12. Transmission channel selector switch

1. Battery compartment