Before The First Use; Contents Of Packing; Intended Use; Before Use - Batavia MAXXPACK BT–CCS002 Mode D'emploi

work area must wear personal protective
equipment. Fragments of work-piece or
of a broken accessory may fly away and
cause injury beyond immediate area of
operation.
• Transport and store the tools in a suita-
ble container.
• WARNING! Do not modify or remove the
protective equipment of the machine. Do
not fit other protective equipment
instead.
• WARNING! Do not use sawblades.
• WARNING! The flange nut must be tight-
ened before starting to work with the
machine.
• Check the grinding disc before use. The
grinding disc must be properly mounted
and turn freely. Perform a test run for at
least 30 seconds without load. Do not
use damaged, out of round or vibrating
grinding disc.
• Immediately switch off the machine in
case of considerable vibrations or if
other malfunctions occur. Check the
machine in order to find out the cause.
• Never reach into the danger area of the
machine when it is running. Chips must
not be removed while the machine is
running.
• The outside diameter and the thickness
of your grinding disc must be within the
capacity rating of your machine.
• Do not use grinding discs that require
liquid coolants. Using water or other
liquid coolants may result in electrocu-
tion or shock.
• WARNING! Do not work with the
machine in conditions with flammable
liquids, gases or dust. The machine pro-
duces sparks able to ignite dust or
fumes.
• WARNING! After switching off, the
machine will not be idle immediately.
(After-running of the grinding disc.) Allow
the grinding disc to come to a stop after
switching off.
• Ensure that the machine is always stable
and secure (e.g. fixed to a workbench).
• In the event of a blockage, switch off the
machine immediately and remove the
battery.
• Only transport the machine by the
handle.

3. Before the first use

Remove the machine and all accessories
from the package. Keep the packaging
materials out of the reach of small children.
There is a danger of suffocation!

4. Contents of packing

1× Cordless chain sharpener
2× Grinding discs: 2.7 mm and 3.2 mm
1× Instruction manual

5. Intended use

This chain sharpener is used to sharpen
chainsaw saw-chains.

6. Before use

Please note that battery and charger are
not included with the tool.
Removing the battery
6.1
To remove the battery from the device,
press the battery release button, then slide
the battery off the recess.
WARNING: Do not try to remove the battery
without pressing the battery release button.
The device or battery could be damaged.
Fitting a battery
6.2
To fit a charged battery, slide it on to the
recess of the device until it clicks and locks
into position.
Note: Make sure the battery and device are
lined up correctly. If the battery does not
slide into the device easily, do not force it.
Instead, slide the battery out of the device
again, check the top of battery and the
device battery slot are clean and undam-
aged and that the contacts are not bent.

7. Assembly

(See Fig. A, B, C).
The saw chain sharpener is supplied partly
assembled to ensure transport protection.
Please assemble the machine as follows:
Place the motor assembly on a solid,
7.1
level surface, e.g. a workbench. Ensure
that the base plate (5) extends out far
English
5