Dexter power CDT219LD.R Manuel D'utilisation page 98

EN
is 2) speeds. A slide switch is located on top of the drill to select either LO or HI speed. When using
the drill in the LO speed range, the speed will decrease and the drill will have greater power and
torque. When using the drill in the HI speed range, the speed will increase and the drill will have less
power and torque.
Gear I
Low speed range: for screwdriving or working with large drilling diameter
Gear II
High speed range: for working with small drilling diameter
WARNING: To prevent gear damage, always allow the chuck to come to a complete
stop before changing the direction of rotation or the two-speed gear control.
9. CHUCK ADJUSTMENT (SEE FIG. I1, I2)
To open the chuck jaws rotate the front section of the chuck in direction 1. Insert the drill bit between
the chuck jaws and rotate the front section in the direction 2. Ensure the drill bit is in the center of
the chuck jaws. Finally, firmly rotate the front chuck section in the directions 2. Your drill bit is now
clamped in the chuck.
10. TORQUE ADJUSTMENT (SEE FIG. J)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment ring. The torque is greater when the torque
adjustment ring is set on a higher setting. The torque is less when the torque adjustment ring is set
on a lower setting.
Make the setting as follows:
1 - 4 for driving small screws
5 - 9 for driving screws into soft material
10 - 18 for driving screws into soft and hard material
for heavy drilling
11. AUTOMATIC SPINDLE LOCK (SEE FIG. K)
The automatic spindle lock allows you to use it as a regular screwdriver. You can give an extra twist
to firmly tighten a screw, loosen a very tight screw or continue working when the battery energy has
expired. For manual screwdriver purposes, the chuck is automatically locked when the tool is off.
12. USING THE SIGHT LIGHT
To turn on the light simply press the on/off switch. When you release the on/off switch, the light will
be off.
LED lighting increases visibility-great for dark or enclosed area. LED is also a battery capacity
indicator. It will flash when power gets low.
13. DRILLING
When drilling into a hard smooth surface, use a center punch to mark the desired hole location. This
will prevent the drill bit from slipping off center as the hole is started. Hold the tool firmly and place
the tip of the bit at the point to be drilled. Depress the switch trigger to start the tool. Move the drill
bit into the workpiece, applying only enough pressure to keep the bit cutting. Do not force or apply
side pressure to elongate a hole.
Tungsten carbide drill bits should always be used for concrete and masonry. When drilling
in metal, only use HSS drill bits in good condition. Always use a magnetic bit holder (not
included) when using short screwdriver bits. When screw-driving, apply a small quantity of liquid
soap or similar to the screw threads to ease insertion.
98