Dexter power CDT219LD.R Manuel D'utilisation page 97

Light
Red on
Red flash
Green on
Green flash
OPERATING INSTRUCTIONS
1. Removing and Mounting Chuck (SEE FIG. B)
To remove the chuck, first depress the Keyless Chuck Button (2), then pull the chuck off toward the
front.
To mount the chuck, first insert the spindle into the chuck, then depress the Chuck release Button
(2) until it clicks into position
2. FITTING AND REMOVING BITS (SEE FIG. C)
After removing the chuck, the tool can be used as a screwdriver. To use any one of the short bits
supplied, insert the bit into the spindle. To remove the bit, simply pull it out of the spindle.
3. HOW TO USE THE BELT CLIP (SEE FIG.D1, D2)
Screw the Belt clip (7) on the tool with the screw provided in the plastic bag. The Belt clip can be
hooked on your belt or pocket, etc.
4. HOW TO USE THE CHUCK CLIP (SEE FIG.E)
Screw the Chuck clip(10) on the tool with the screw provided in the plastic bag. The Chuck clip can
hook the chuck
5. ON / OFF SWITCH (SEE FIG. F)
Depress the On/Off switch to start and release it to stop your drill. The on/off switch is fitted with a
brake function which stops your chuck immediately when you quickly release the switch.
It is also a variable speed switch that delivers higher speed and torque with increased trigger
pressure. Speed is controlled by the amount of switch trigger depression.
WARNING: Do not operate for long periods at low speed because excess heat will be
produced internally.
6. SWITCH LOCK
The switch trigger can be locked in the OFF position. This helps to reduce the possibility of
accidental starting when not in use. To lock the switch trigger, place the rotation control in the center
position.
7. REVERSIBLE (SEE FIG. G1, G2)
For drilling and screw driving use forward rotation marked "
use reverse rotation marked "
jammed drill bit.
WARNING: Never change the direction of rotation when the chuck is rotating, wait until it has
stopped!
8. TWO-SPEED GEAR CONTROL (SEE FIG. H)
The drill has a two-speed gear control designed for drilling or driving at LO (mark is 1) or HI (mark
ON/OFF flash
________
_ _ _ _
________
_ _ _ _
" (lever is moved to the right) to remove screws or release a
Status
Charging
Defective Battery
Fully Charged
Hot/Cold Delay
" (lever is moved to the left). Only
EN
97