Software Installation; Hardware Installation - Lindy 43173 Manuel D'utilisateur


Update driver by windows update.

At least one USB 3.0 port.

30 megabytes (MB) of free disk space.

Computer screen for use with the USB 3.0 HDMI Adapter

Network access for software downloads, or access to a CD-ROM
drive.

Software Installation

Install the software application first and do not connect the USB 3.0
HDMI Adapter to your PC before the installation has completed!
a. Insert the supplied installation CD and run the E: \SETUP.EXE file
(Assuming your CD ROM drive is located at E:\)
b. Windows will pop up a "DisplayLink Software" screen as below, please
click "I accept" to start installation process. The set-up program will in-
stall the device driver & software application.
Note: The screen may flash or go black during the installation; no mes-
English
sage will be shown at the end of the installation process.

Hardware Installation

a. Connect your USB 3.0 HDMI Adapter via the USB cable to your PC.
You will then see the following message:
b. When connecting the USB 3.0 HDMI Adapter, your system will initiate
the driver and software application (the DisplayLink Software Config-
uration screen may flash or go black during the install).
Note: On some machines you may need to reboot before you can begin to
use your USB 3.0 HDMI Adapter.
c. Once the installation is complete connect your monitor to the USB 3.0
HDMI Adapter.
E n g l i s h