Table Des Matières; Introduction; Safety Warnings - Global Industrial 988955 Manuel De L'utilisateur

1.

INTRODUCTION

Become familiar with the location and function of all
controls before operating the truck. Do not use this truck
unless you have been trained and authorized to do so.
All information, specifications, and illustrations in this
manual are based on the latest data available at the time
of publication. Our company reserves the right to make
changes or improvements at any time without notice.
With proper operation and scheduled maintenance, this
truck should provide years of productive service.
1.1 Modifications and Additions
Any changes, additions or modifications will void the
warranty. Do not cover or remove safety decals.
2.

SAFETY WARNINGS

Safe operation of the truck depends upon the
following:
• The operator's knowledge, skill and training
• Equipment maintenance
• The operator's high regard for personal safety and
the safety of others
• A safe and suitable working environment
2.1 Safety Guidelines
Read and understand the following safety guidelines
for maximum safe operation of this electric truck.
• Read and obey all warnings
and instructions contained in
this manual.
• Operate this truck only from
the designated operating
position.
• Never carry passengers.
• Never let anyone stand on or under the forks.
• Drive the truck safely. Always keep it under
control.
• If you lose control of the truck, let go of the control
handle and quickly move away from the truck.
• Elevate the lifting mechanism only to pick up a
load. Stunt driving and horseplay are dangerous to
personnel and equipment, and are not permitted.
• Do not overload the truck. Check the capacity
plate for load weight information.
Powered Drive Straddle Trucks
TABLE OF CONTENTS
1. Introduction ...................................................... 2
2. Safety Warnings ............................................... 2
3. Main Parameters .............................................. 4
4. Operation Instructions ................................. 5-7
5. Battery Charging .............................................. 7
6. Inspection And Maintenance .......................... 8
• Operate on a flat, smooth surface.
• Start, stop, change direction, travel, and brake
smoothly. Slow down for turns and uneven or
slippery surfaces that could cause the
truck slide or tip. In any application,
always approach and leave the aisle
slowly.
• Be aware of objects protruding from
racks, shelves and walls that can
cause injury or come into contact with the truck.
• Operate the truck slowly and in an open area until
you become thoroughly familiar with the truck
controls.
• Use extreme care when traveling without a load.
Excessive speed with abrupt turns or on uneven
surfaces may cause the truck to tip when empty
as well as when loaded.
• E
xamine the load before moving to ensure that it
is securely and safely loaded.
• Always look in the direction of travel. Keep a clear view.
• When the load interferes with visibility, face the
direction of travel with the load trailing.
• Do not handle unstable or loosely-stacked loads.
Use special care when handling long, high, or
wide loads.
• Obey all applicable traffic regulations. Yield the
right-of-way to pedestrians. Drive on the right
unless your work area follows different rules.
• Always stop the truck and sound the horn when
approaching crossing aisles, when entering or
exiting an aisle, or when visibility is obstructed.
• Keep your hands and fingers inside the protected
area of the control handle.
• Ensure there is enough light.
• Do not operate unit near personnel.
• If you leave the electric truck unattended, fully
lower the forks, shut the power off, remove the
key from the optional key switch (if your truck has
this option), and disconnect the battery.
2
User's Manual
NO
SLOPE