ACDelco ARS1214 Manuel Informations Du Produit page 12

4. Release the switch to the OFF position.
5. Remove the wax applicator pad from the sanding pad.
a. Use the pad to hand polish hard to reach surfaces.
b. Dispose of the pad properly. DO NOT reuse it.
NOTE
1. This action is not necessary on irregularly shaped surfaces.
2. If the bonnet comes off during use, you may be using too much wax or running
the tool when it is not on a work surface.
3. The wax and polishing solution containers shown in the illustrations is
representative. Actual containers may vary.
BUFFING EXCESS WAX FROM SURFACE OR POLISHING A WAXED
SURFACE
1. Put the wool bonnet or the polishing bonnet. Make sure the bonnet band securely and
evenly around the foam pad.
2. Place the tool on the surface and press the switch to the start position.
3. Buff or polish the wax on the work surface in the same order it was applied.
a. Use across-the-board strokes in a crisscross pattern on flat surfaces.
b. Do not press down on the polisher while using. The weight and rotation of the tool
make the work go well.
4. Release the switch to the OFF position.
5. Remove the wool bonnet or the polishing bonnet from the sanding pad.
1English1
English -11