Face Shield With Anti-Fog Lens - Schubert S2 SPORT Mode D'emploi

C. THE HELMET

10. FACE SHIELD WITH ANTI-FOG LENS

The face shield is a fog-free double-lens visor. By fixing the inner anti-fog
lens using eccentric pins, the two visor panes are pre-tensioned together and
are thereby sealed. An insulating air cushion is thus formed between the
visor's main plate – i.e. the outer plate – and the inner plate, which prevents
any fogging up of the inner plate.
COATING
The main plate has a HighClear anti-scratch coating on both sides.
®
Note:
The helmet should never be used to hold gloves or any other objects as
this may damage the scratch-sensitive anti-fog lens.
Note:
The anti-fog lens is supplied with a protective film. Remove this film
before using the helmet for the first time.
Note:
The anti-fog lens may only be used in conjunction with the
SCHUBERTH main face shield that has been specially designed for this
purpose. Other face shields must not be fitted.
OPENING THE FACE SHIELD
To open the face shield, use your thumb to push the
face shield up using one of the finger tabs situated to
the left and right of the face shield, and move it to the
desired position.
56
Face shield (including urban position)
The face shield can be locked in any one of seven positions. The second
position (urban position) locks in place more firmly, providing greater resi-
stance when the face shield is in this position. This makes it easier to lock
the face shield in the urban position, especially while riding.
When you push the face shield open, it may well travel beyond the urban
position, but it is easy to find this position by moving it downwards again.
The face shield mechanism requires no additional lubrication. The face shield
can be operated at any time irrespective of the position of the sun visor.
CLOSING THE FACE SHIELD
To close the face shield, grip the finger tabs at top
left and right and press the face shield down with
one movement until it audibly locks into place.
REPLACING THE FACE SHIELD
Changing the visor shield is easy to do without tools using the convenient
EasyChange visor mechanism. To replace the visor, it is helpful to place the
helmet on a flat surface or on your lap while seated.
EN
57