Technical Data; Care Instructions - DuschWelten MK 160 Instructions De Montage

Technical Construction Requirements
1. Recommended minimum ceiling height 2200 mm
2. Installation on tiled walls
3. Pressure: (cold and hot water as equal as possible)
min.flow pressure = 3 bar
max.flow pressure = 5 bar
Flow pressure greater than 5 bar = pressure reducer
required
Tip:
Definition "flow pressure": pressure of the water
coming out of the pipes.
4. Mixed Water Supply
A mix and dosage fitting must be located before the
Shower-Set to regulate the water temperature.
Regulation via e.g.:
a) One-handed lever mixer with a 1/2" male thread mi-
xed water connection
b) Thermostat and concealed stop valve with a 1/2"
male thread wall connection elbow
Length of hose: 1000mm (included)

Care instructions

The different surfaces of today's faucetes require a meticulous care and cleaning regime.
The following rules apply:

Regular cleaning prevents the build-up of lime-scale!

Use a purpose recommended cleaner.
Caution: Any cleaner containing acetic acid, hydrochloric acid, chlorine
bleach or formic acid can cause considerable damage!

Adhere to the respective manufacturers instructions for cleaning.

Rinse with cold water after each period of cleaning.

No abrasive cleaning agents (scouring pads, etc.)

Do not spray the cleaning agent directly on the product, but
apply with a cloth (this prevents the accumulations of detergent)

No high-temperature cleaning agents (steam cleaners)

Do not use or store chemical cleaners near the fittings. The
release of chemicals can damage the fittings.

Damaged surfaces facilitate the penetration and infiltration of
detergents under the chrome plating which will enhance the damage.

Technical data

1. Measurements:
Height: 1020 mm
Width: 250 mm
Depth: 450 mm
2. Equipment:
– Chrome-plated brass basic frame
– Large shower head
– Handset
– switcher between handset and shower head
3. Use at 3 bar flow pressure
Shower head: 9 l/min
Handset: 7 l/min
Tip:
The intensity for the individual user depends on the flow
pressure.
Technical data not guaranteed.
We reserve the right to make changes.
!
!
- 6 -
The nozzle on the hand / or head
shower need to be regularly in
order to prevent the build-up
of lime-scale on the nozzles.
By sweeping the back
of your hand or your
thumb over the nozzle.
Damage caused by
inadequate or improper
cleaning are covered by
the warranty conditions.