Inomak UFI1170SL Directives D'installation, D'utilisation Et D'entretien page 66

SERIAL INPUT OF THE THERMOSTAT
RN5 can connect to CAMIN network or to data logger model Mini Logger or to any MODBUS network:
 CAMIN network: the thermostat can connect via a network interface NET-INS-485 to the CAMIN network. CAMIN is a software application designed to collect data, monitor
and fully control a network of up to 250 thermostats using cable wiring. It can also send SMS and emails in case of an alarm.
 Mini Logger: the thermostat can connect to a data logger and store temperatures, relay status and alarms to a microSD. A cable is used to connect the data logger with the
thermostat and parameter Add must be adjusted to 1.
ELECTRICAL DIAGRAM OF THE THERMOSTAT
ATTENTION: according to safety standards, the device must be properly positioned and protected from any contact with electrical parts. The device must be fastened in such a way that it cannot
be removed without the use of tools. Disconnect the main safety switch of the installation before proceeding to any maintenance. Disconnect the power supply of the device before proceeding to
any maintenance. Do not place the device near heat sources, equipment containing strong magnets, in areas affected by direct sunlight or rain. Prevent electrostatic discharges and sharp objects
from been inserted to the device. Separate signal cables from power supply cables to prevent electromagnetic disorders. Signal cables must never be in the same pipe with the power supply cables.
ELECTRICAL DIAGRAM OF THE CABINET
ATTENTION: according to safety standards, the device must be properly positioned and protected from any contact with electrical parts. The device must be fastened in such a way that it cannot
be removed without the use of tools. Disconnect the main safety switch of the installation before proceeding to any maintenance. Disconnect the power supply of the device before proceeding to
any maintenance. Do not place the device near heat sources, equipment containing strong magnets, in areas affected by direct sunlight or rain. Prevent electrostatic discharges and sharp objects
from been inserted to the device. Separate signal cables from power supply cables to prevent electromagnetic disorders. Signal cables must never be in the same pipe with the power supply cables.
Refrigerated counters
Upright chiller
Saladette / Counter with glass door
Upright freezer with glass door
Upright freezer with stainless door
3