Remote Control (Optional) - NESTOR MARTIN M43 Instructions D'installation, De Service Et D'entretien

3.3.4. Minimum air setting.
The adjustment knob for the minimum air intake can be found
underneath the stove, on the air flap assembly. It is factory set. This
knob allows you to increase, decrease or completely close the
permanent air intake.
Adjust this knob according to your chimney's draught, when the
chimney is at its operating temperature and using an accurate flue
draught gauge. See section 2.1.1, Chimney height requirements, for
Adjustment knob
the recommended flue draft.
Fig. 13
Minimum air screw open
(this is the factory setting, suitable for a
normal flue draught).
Minimum air screw closed or nearly closed
(in the case of an excessively strong flue
draught)

3.3.5. Remote Control (optional)

This stove has the option of remote control.
Fitting the remote control motor:
At the rear of the appliance you will see the motor fitting bracket.
This incorporates a magnet and the mechanism friction plate. The friction plate
is hinged. To fit the motor, this friction plate needs to be detached from the
magnet and swing to the left. The motor can now be slipped into place. The
Fig. 14
magnet retains the motor.
Fig. 15 Fig. 16
53