About These Instructions - NESTOR MARTIN M43 Instructions D'installation, De Service Et D'entretien

ABOUT THESE INSTRUCTIONS

These instructions cover the Nestor Martin M43
Woodbox® stoves with the TruHybrid system. It offers
installation and operation information for this model.
TruHybrid Woodbox® stoves
Increase the efficiency of your stove while taking care
of the environment.
In addion to the reduction of fuel consumption, thanks
to this new system the emissions that occur during
combustion are also significantly reduced.
It is only recommended that dry seasoned wood with a
moisture content of 20% or below be used in the
TruHybrid stoves.
The burning of smokeless coal is not recommended as
this can reduce the life of the catalyst used in the
TruHybrid system.
For full instructions for the TruHybrid stoves please
refer to the instructions specific for this variant
supplied with the stove.
Model Idenfication
There is a stove idenfication plate fitted to the stove
giving the details of each appliance.
This can be found in a number of places on the stove
depending upon the model and date of manufacture:
1. On a plate that swings out from under the ashpan
housing.
2. On a plate that swings out from the left hand side
of the rear heat shield.
3. A label fitted on the rear of the stove towards the
boom of the rear heat shield.
WARNINGS
Due to the high operating temperatures of this
appliance it should be located away from pedestrian
traffic and away from furniture and draperies.Mats and
rugs put in front of the stove should be fire proof and
secured to prevent the possibility of tripping.
Do not store paper or wood near the appliance. Do not
store or use petrol or other flammable vapours and
liquids in the vicinity of this or any other heang
appliance. Do not use aerosol sprays near the stove
when the stove is alight. Do not burn anything but
natural wood or approved smokeless coals on this
appliance.
Advise all persons as to the stove's high surface
temperatures. If it is possible for children or infirm
adults to come into contact with the stove, fit a suitable
fire guard.
It is imperave that all air passageways into, out of, and
within the appliance are kept clean. All permanent
venlation into the room provided for the stove must
remain clear and unobstructed at all times.
Consideration must be given to the need for extra
venlation if another heating source needing air is to be
operated simultaneously. If an extraction fan is
proposed to be fitted to a connecting area of the
house, after the stove has been installed, professional
advice should be sought from a qualified engineer.
The user should be advised that the appliance should
be inspected regularly and the chimney cleaned at
least annually. More frequent cleaning may be
required and the advice of a qualified chimney sweep
should be sought.
Your attention is drawn to the precautions and
responsibilities under the Health and Safety at Work
Acts, and whatever new legislation being introduced
during the life of this document. Especially to the
possibility of disturbing asbestos when disturbing
structures in older properties. Also the caustic nature
of fire cement. The personal risk of injury when moving
heavy items with possible sharp edges.
Improper adjustment, alteration, maintenance or the
fitting of replacement parts not recommended by the
manufacturer can cause injury or property damage.
Do not operate the stove with faulty seals or damaged
glass.
45