Installing And Operating Your Fridge; Before Using Your Fridge - Ocean OCM 402 TNF X A++ Guide D'utilisation

• When the door of the cooler is closed, a
vacuum seal will form. Wait for about 1 minute
before reopening it.
• This application is optional for easy opening
of the door. With this application, a little
condensation may occur around this area and
you may remove it.

Installing and Operating your Fridge

Before starting to use your fridge, you should pay attention to the following points:
• Operating voltage for your fridge is 220-240 V at 50Hz.
• We do not take the responsibility of the damages that occur due to ungrounded usage.
• Place your fridge in a place that it would not be exposed to direct sunlight.
• Your appliance should be at least 50 cm away from stoves, ovens and heater cores, and
should be at least 5 cm away from electrical ovens.
• It should never be used outdoors or left under the rain.
• When your fridge is placed next to a deep freezer, there should be at least 2 cm between
them to prevent humidity on the outer surface.
• Do not place anything on your fridge, and install your fridge in a suitable
place so that at least 15 cm is available on the upper side.
• If you will place your fridge next to your kitchen cabinets, leave a space
of 2 cm between them.
• Fit the plastic wall spacers to the condenser at the back of the refrigerator
in order to prevent leaning to the wall for good performance.
• Install the distance adjustment plastic (the part with black vanes at the
rear) by turning it 90° to prevent the condenser from touching the wall.
• Refrigerator should be placed against a wall with a free distance not
exceeding 75 mm.
• The adjustable front legs should stabilized in an appropriate height to
allow your fridge operate in a stable and proper way. You can adjust the
legs by turning them clockwise (or in the opposite direction). This should be done before
placing food in the fridge.
• Before using your fridge, wipe all parts with warm water added with a tea spoonful
of sodium bicarbonate, and then rinse with clean water and dry. Place all parts after
cleaning.

Before Using your Fridge

• When it is operated for the first time or after transportation, keep
your fridge in the upright position for 3 hours and plug it on to allow
efficient operation. Otherwise, you may damage the compressor.
• Your fridge may have a smell when it is operated for the first time; the smell will fade
away when your fridge starts to cool.
EN - 5 -