Using With My Needo - NEEDO T750H Mode D'emploi

USING WITH MY NEEDO

Needo radiators can be easily controlled using the My
NEEDO remote control.
For this to be possible, a "binding" procedure must
be carried out, as shown below, to allow one or more
radiators to be linked to My NEEDO.
Initial installation – binding phase
1 Check that the radiator is receiving power. The LED
on the powerbox flashes in network search mode;
2 Insert the batteries in My NEEDO or connect it to
the USB port;
3 My NEEDO goes into
NEEDO User Guide);
4 Once "Install Radiator" has been pressed, My NEEDO goes into
message "Press the Powerbox button within the
min. press the powerbox button once; the LED starts to flash green rapidly;
5 If binding has been carried out successfully, My NEEDO will request that you enter a
name for the radiator (see My NEEDO User Guide);
6 The radiator is now linked and can be used;
7 To install other radiators, repeat points 4 to 6 or press
procedure.
Subsequent installations
When a new radiator is installed, it can be linked to the My NEEDO that is already in
operation.
1 Press MENU;
2 Access the Assistance
3 Select Maintenance
4 Repeat points 4 to 6 of
initial installation mode
menu;
and press OK;
"initial installation" for each new radiator.
and requests parameters to be set (see My
stand-by mode
minute" appears on the screen...; Within 1
MENU to exit the installation
EN
and the
35