AEG FAVORIT 50KVI1P Notice D'utilisation page 29

7.2 Setting and starting a
programme
Setting mode
The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation the display shows 2
horizontal status bars.
If the control panel shows other condi-
tions, press RESET until the appliance is
in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Set the programme.
• The related programme number
flashes in the display.
4. If you want, you can set the options.
5. Close the appliance door. The pro-
gramme starts.
• If you open the door, the display
shows the programme duration
that decreases with steps of 1 mi-
nute.
Starting a programme with
delay start
1. Set the programme.
2. Press the delay button again and
again until the display shows the de-
lay time you want to set (from 1 to 24
hours).
• The delay time flashes in the dis-
play.
• The delay indicator is on.
3. Close the appliance door. The count-
down starts.
• If you open the door, the display
shows the countdown of the delay
start that decreases with steps of 1
hour.
When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.
Cancelling the delay start
while the countdown operates
When you cancel a delay start, the appli-
ance goes back to setting mode. You
have to set the programme again.
1. Press RESET until the display shows 2
horizontal status bars.
Cancelling the programme
1. Press RESET until the display shows 2
horizontal status bars.
Make sure that there is detergent
in the detergent dispenser be-
fore you start a new programme.
At the end of the programme
When the programme is completed, an
intermittent acoustic signal operates.
The display shows 0 and the end indica-
tor comes on.
1. Press the on/off button to deactivate
the appliance.
2. Close the water tap.
If you do not press the on/off
button, the AUTO OFF device
automatically deactivates the ap-
pliance after some minutes. This
helps to decrease the energy
consumption.
Important
• Let the dishes become cold before
you remove them from the appliance.
Hot dishes can be easily damaged.
• First remove the items from the lower
basket, then from the upper basket.
• There can be water on the sides and
on the door of the appliance. Stainless
steel becomes cool more quickly than
the dishes.
ENGLISH
29