AEG FAVORIT 50KVI1P Notice D'utilisation page 27

1) Factory position.
2) Do not use salt at this level.
How to adjust the level of the
water softener
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
"Setting and starting a programme".
2. Press and hold, at the same time,
button and button
indicators of buttons
and start to flash.
3.
Press button
• The indicators of buttons
and go off.
6.2 Filling the salt container
until the
, ,
.
,
•
The indicator of button
tinues to flash.
• The acoustic signals operate, e.g.
five intermittent acoustic signals =
level 5.
• The display shows the current set-
ting of the water softener, e.g.
= level 5.
4.
Press button
change the setting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt con-
tainer (only for the first time).
3. Fill the salt container with dishwash-
er salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out
from the salt container when you
fill it. Risk of corrosion. To pre-
vent it, after you fill the salt con-
tainer, start a programme.
ENGLISH
27
con-
again and again to