Cleaning And Maintenance - AEG HR 5625 Mode D'emploi

English
46
Using the long hair cutting attachment:
Use the long hair cutting attachment to precisely cut the hair or beard.
• Use the slide control to release or retract the long hair cutting attachment.
Stop operation
Stop operation by pushing the switch downwards. 0 will be visible.

Cleaning and Maintenance

WARNING:
• Disconnect the hand-held unit from the power supply before cleaning.
• Disconnect the mains adapter from the wall socket when cleaning.
• Do not immerse the parts into water.
CAUTION:
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
Shaving head with shaving blades
The shaving head can be removed and then be cleaned under running water.
1. Switch of the shaver.
2. Press the shaving head buttons. Remove the shaving head.
3. Rinse the shaving head under running hot water. Clean the shaving head in soapy
water once in a while.
4. Rinse thoroughly with clear water afterwards.
5. Let the cleaned parts dry.
Cleaning the cutter blocks and inner surface
CAUTION:
The shaving foil must not be cleaned with the brush.
• Use the brush to clean the shaver' s cutter blocks and inner surface.
Cleaning the hand-held unit and mains adapter
• You may wipe these parts with a damp cloth.
• Use slightly soapy water to remove spots.