PNI HUNTING 280C Manuel De L'utilisateur page 14

Timer
Time Lapse
Delay
Battery Type
Other
Reset
About
User manual
Select ON and press OK to set the camera
start time and stop time (hour/minute). The
camera will operate only during the set time
interval.
Select ON and press OK to set the interval at
which the camera will take photos and recordings.
The camera's PIR sensor will be disabled.
Configurable interval: between 5 seconds and
24 hours.
Note: Do not activate the Time Lapse and Delay
functions simultaneously.
Select ON and press OK to set the time after
which the camera will fire (photo or video) when
motion is detected. By activating this option,
the camera will not take too many photos and
videos.
Example: The camera will wait 1 minute between
triggers when it detects motion, if the set interval
is 00:01:00
Configurable options: between 0 seconds and
24 hours
Note: Do not activate the Time Lapse and Delay
functions simultaneously.
Alkaline/Ni-MH
Choose the correct type of batteries inserted in
the camera to ensure proper operation.
SD-Cycle
Select ON and press OK to activate the cyclic
recording. The camera will delete older files
when the memory is full.
Frequency
50Hz/60Hz
Incorrect frequency setting may cause the
screen to flicker.
Select Yes to return the camera to the factory
settings
The camera firmware version is displayed
14