Intended Use; Safety Information For The Installer - Harvia Xenio RGBW Instructions D'installation Et D'utilisation

Instructions for installation and use
1. About this instruction manual
Read these installation and operating instructions carefully and keep them close
to the infrared control unit. This ensures that you can refer to information on
safety and operation at any time.
These installation and operating instructions can also be at
https://mediabank.harvia.com.
2. Important information for your safety
The Xenio RGBW colour light control has been manufactured ac-
cording to the applicable safety regulations. However, hazards may
arise during use. Therefore adhere to the following safety information
and the specific warning notices in the individual chapters.

2.1. Intended use

The Xenio RGBW colour light control is used to control LED RGBW
spots and RGBW tubes using DMX CC / CV drivers.
Any use exceeding this scope is considered improper use. Improper
use can result in serious injury or damage to the product.

2.2. Safety information for the installer

● It may only be fitted and installed when the power has been
disconnected.
● Installation may only be performed by a qualified electrician or
similarly qualified person.
● For your own safety, consult your supplier in the event of prob-
lems that are not explained in sufficient detail in the installation
instructions.
p. 1/7