Uniteck UNIDETECT Mode D'emploi page 11

 Finalize the assembly
STAGE AREA SETTINGS
The system will perform an automatic 30-second test. During the test, the connected instrument remains
on. When it turns off, a range test starts. Now, in the event of movement, the device will activate for about
5 seconds, regardless of the ambient light level (at each movement, the luminaire will turn on again for 5
seconds). Once you have made this setting, you can make further settings.
Activate mode
 If your motion detector is connected to a switch, make sure it is in the ON position.
Positioning :

- The LUX button on the sun symbol
- The TIME button on 10s,
www.uniteck.fr
EN
11/24