Siemens LI2USB Notice De Montage page 13

Installation
This extractor hood is intended to be
mounted onto the kitchen wall.
Note: Take into account any special
accessories that are going to be fitted.
1. Remove the grease filter (refer to
Operating Instructions).
2. Draw a line on the wall from the ceiling to
the lower edge of the hood at the centre
of the location where the hood is going to
be mounted.
3. Using the template, mark positions on the
wall for the screws.
Ensure that the minimum distance
between the hob and the extractor hood is
maintained – 600 mm for an electric hob and
650 mm for a gas hob. The bottom edge of
the template equates to the lower edge of
the extractor hood.
4. Drill 2 holes (dia. 8 mm) for the extractor
hood.
Drill 2 holes (dia. 8 mm) for the bracket
for fixing the flue ducts - use the bracket
as a template: this should be fit close to
the ceiling so that index printed on the
bracket matches with the line previously
marked (see step 2).
Insert wall plugs flush with the wall.
5. Screw on the bracket for fixing the flue
ducts.
6. In order to help fix the hood onto the wall,
screw in 2 screws until it protrudes by
approx. 5 mm.
7. Hook the extractor hood over the screws
in the wall, align the extractor hood
properly.
8. Mark 2 lower fixing points.
Remove the hood and drill 2 holes (dia. 8
mm) on the marked points. Fit 2 wall
plugs, Hang again the hood and fix the
hood permanently with 2 screws.
13