installation
EN
3.6
three-sided, two-sided, and single-sided viewing pre-installation
note:
It is recommended to lay the appliance on a stable surface before pre-installation.
1. Remove the 12 screws and washers from the top and bottom of the appliance (Fig. 3-1).
2. Install the 6 metal brackets (supplied) using the 12 screws and washers previously removed (Fig. 3-2).
C x 6
Fig. 3-1
Fig. 3-2
3. Remove the side trims and side panels from both sides of the appliance by removing the 14 screws (Fig.
3-3). Set the side trims, side panels, and screws aside.
Side
Side Trim
Trim
Side Panel
Side Panel
Fig. 3-3
13
W415-1953 / C / 03.04.21