Operation - CareCo A7DH45B2AA Manuel D'installation Et D'utilisation

B
A
Power Indicator
A
Press "Power" button to activate unit. Power "On" indicator lights up. The unit is pre-set to
maintain a 60% relative humidity level.
Container Full Indicator
B
An automatic overflow switch and Container "Full" indicator light are provided to turn the
dehumidifier off before the container overflows. When the indicator light on the control panel
glows, the water container must be emptied. If the light remains on and the dehumidifier does
not begin to operate make sure the float is attached to the water container.
Set Humidity Display
C
If "Set Humidity" level is lower than the "Room" humidity level: the compressor will start up
and unit will start dehumidification.
If "Set Humidity" level is higher than the "Room" level: the unit will not dehumidify.
After operating several days at the default setting, with doors and windows closed, you may
adjust the "Set Humidity" to a slightly lower percent (drier air) or higher percent (moist air). If
you would like to adjust the "Set Humidity" humidity level, press the "+" or "-" to adjust the
humidistat in 5% increments between 35% and 90%.
Room Humidity/Temp Display
D
The "Room" display will display either the relative humidity or temperature of the room. The
default setting is room humidity. To display the temperature of the room press the
"Humidity/Temp" button. Press it again to go back to the humidity level.
To display the Temperature in Centigrade: hold down the "Humidity /Temp" button
for 5 seconds.
Fan speed Control
E
Press the "Fan Speed" button if you would like to change the fan speed from "Low" to "High",
Use the high speed to maintain maximum water removal. The lower speed can be used when
quieter operation is desired.
Pause Feature
F
Press "Pause" button to pause operation of dehumidifier for 1 hour.
In general, dehumidification is not usually needed during conditions of low room temperature.
Optimal relative humidity is between 40 and 50%.
This electronic controlled unit will automatically resume operation after a power failure.
D
C
F
E
2

OPERATION