Distance between the ridge and
the hole axial : 20mm
Location of the plastic
spacers L : 10mm
Fitting kit
- 4 BHc 5×25 screws
- 4 rubber insert
- 2 6×10 plastic spacers
Assembly
- Thanks to a soft lead pencil, mark the holes axial to drill on the fairing.
- Drill very carefully with a small diameter first (for example Ø4mm), then do it with a bigger
drill up to the final size (9,5 mm).
- Fit the nose screen thanks to the supplied screws by inserting the spacers between the screen and
the nose fairing (for location, see photo).
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjusting to fit.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
Distance between the upper ridge and
holes axial : 15mm
ADAPTABLE ON B-KING 1300 2008 → ∞
- 4 Ø5 plastic washers
- 2 6×5 plastic spacers
« CAUTION »
FITTING INSTRUCTIONS
ERMAX NOSE SCREEN
Distance between the ridge and
hole axial : 25mm
Location of the plastic
spacers L : 5mm