Konig Computer CMP-MOBDOCK10 Mode D'emploi page 3

3.4 Start to Use
1. The docking supports 2.5" or 3.5" SATA HDD directly plug in to the SATA connector , which
is instructed by below photo 1 and 2.
2. You can easily hot-swap the HDD by directly pulling it out from the docking , which is
instructed by below photo 3 and 4.
4. Using the Docking
4.1 In Windows Vista, Windows XP, Windows 2000, Windows ME and Mac OS
The Docking can work under Windows Vista/XP/2000/ME and Mac OS without any extra
driver.
4.2 Using in Windows 98SE
1. Windows 98 driver, it is "SPIF225_Installer.exe" which you can fi nd from driver CD
2. Connect USB cable to Docking & PC, USB icon will appear in the system tray.
3. To Safely remove the disk, please right click the USB icon and click "Safely Remove".
Note:
1. If you can see the USB icon, but can't fi nd new disk appearing in your computer, please
check if the hard disk was partitioned.
2. If HDD has been partitioned, please make sure the format of your HDD is FAT32.
Because Windows 98 doesn't support NTFS format of HDD.
3