Hama MyVoice 1300 Mode D'emploi page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 21
• The headset and the terminal device should not be any further than
1 metre away from each other. The smaller the distance, the better.
• Ensure the headset is off.
• Device off: Switch on the headset using the on/off switch (1).
A voice says, 'Power on' and the LED indicator (3) flashes white.
The headset is searching for a Bluetooth
• Open the Bluetooth
until MyVoice 1300 appears in the list of Bluetooth
found.
• Bluetooth
devices found.
®
• Select MyVoice 1300 and wait until the headset is listed as
connected in the Bluetooth
Note – Bluetooth
If your terminal device requests a password to establish the
connection, enter 0000.
Note
If pairing was successful, the status LED (3) flashes slowly. A voice
says, 'Connected'.
• You can now use the headset.
5.2. Automatic Bluetooth
(after successful pairing)
Note
• Make sure that your Bluetooth
and Bluetooth
• For more information, please refer to the operating instructions of
your terminal device.
• Make sure that the headset is switched on.
• After the headset and terminal device have been paired, a
connection is established automatically.
• You can now use the headset.
Note
• If pairing was successful, the status LED (3) flashes slowly. A
voice says, 'Connected'.
• It may be necessary to change the settings on your terminal
device to enable it to automatically connect to the paired
headset.
settings on your terminal device and wait
®
settings on your terminal device.
®
password
®
connection
®
is activated.
®
connection.
®
-capable terminal device is on
®
devices
®
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

00177060

Table des Matières