Assembling The Cutting Equipment; Fitting Other Guards And Cutting Attachments - Husqvarna 524LK Manuel D'utilisation

Assembling the cutting
equipment
WARNING!
!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
Fitting other guards and cutting
attachments
• Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
guard onto the fitting on the shaft and secure with the
bolt (L).
A
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
12 – English
ASSEMBLY
•
•
B
C
A
Screw on the trimmer head/plastic blades (H) counter
clockwise.
H
H
To dismantle, follow the instructions in the reverse
order.
1158418-49 Rev. 3 2018-10-08