Before Recording - Teac LP-R550USB Mode D'emploi

Listening to a Cassette Tape 2
To stop playback
A
Press the STOP button (H) during playback to stop.
To pause playback
B
Press the PAUSE button (J) during playback .
Press the button again to start playback again.
< To enter PAUSE mode at the current position, order of pressing
the PAUSE button first and then pressing the PLAY button is
required in the STOP mode.
Fast-forwarding/rewinding
C
Press the F.FWD or REW button (,/m) to fast-forward or
rewind a tape respectively.
To stop fast-forwarding or rewinding, press the Stop button (H).
Never press the PLAY button (y) and REW button (m) at
the same time.
When a tape is fast-forwarded to the end or rewound
to the beginning, the function does not stop
automatically. Make sure to press the STOP button
(H) to stop the function.
24

Before Recording

Before you start recording, make sure that you understand
the following points:
< CD specifications limit the number of tracks to 99.
< You can not create recording tracks shorter than 10 seconds.
< Once you have recorded on a CD-R disc, the data cannot be
erased.
< A recorded CD-R can be played back in a regular CD player after
finalizing.
< To add more recordings to a finalized CD-RW, unfinalize it. (See
page 29.)
When all available space on a CD-RW has been recorded, you can
record additional tracks by erasing previously recorded tracks.
Note that you can only erase all tracks or the last track.
< If the STOP button (H) or PLAY/PAUSE button (y/J) is pressed
within 10 seconds from the beginning of recording, the unit does
not stop recording.
< When the recording is finished, "REC" and "- ENd - " blink for a few
seconds, and the unit then goes into stop mode. Do not apply
any shock or vibration to the unit during blinking.
< If the disc reaches the end during recording, the unit finalizes the
disc automatically and stops.
< If the disc reaches the end of the 99th track during recording, the
unit finalizes the disc automatically and stops.
< The recording time of a track may differ slightly from the original
one.
< When a partially recorded disc is inserted, recording starts after
the last recorded track.
< The AUTO REC function automatically divides an audio source in
tracks according to the sound level that has been set (See page
25). Therefore, a finished copy could have more tracks than its
original source. if the source that is recorded using this function
contains noise or quiet parts at the beginning of or between
tracks.
< When the TRACK INCREMENT button is pressed while recording,
the recorded sound will be cut for a moment.
Do not use the TRACK INCREMENT function while the music
sound continues.
< When the disc which was recorded by this unit is played back on
some other players, a small noise may be heard at the point that
the track is divided.