Table des Matières
Publicité
To ensure your machine remains at its maximum efficiency and prolong your battery life,
please follow the simple steps below:
49
50
52
Machine Charging
The battery charge level meter displays the charge level of the batteries; when fully charged,
all meter lights are illuminated (Fig.49).
As the machine is used and the batteries are discharged, the battery charge level meter lights
will go out from top to bottom.
If the battery charge level is allowed to discharge to the point that only one red light remains
illuminated, the operator should charge the battery.
Batteries from new, typically retain only 80% of its stated capacity.
Batteries will increase to their full capacity after 5-10 charge / discharge cycles.
Charge time for a fully discharged battery, is approximately 8 hours for the
TTB 4055/100T / TTB 4552/100T Range.
Spare replacement batteries are available from your supplier.
Under normal daily usage:
Recharge batteries after each use, regardless of
Connect the charger lead supplied,
into your machine (Fig.50).
Then plug into a suitable power supply (Fig.51)
Recharge the machine fully after its last use.
Do not leave the machine in a discharged state.
machine operation time.
Remove the top tank to view the charging light panel
located on the front plate.
Viewing panel for charging-light sequence (Fig.52).
42
51
Publicité
Table des Matières
