newmotion Home Advanced 2.0 Manuel D'installation page 16

6. PRODUCT USE / OPERATION
6.1 BEFORE USE: ACTIVATION &
REGISTRATION
To make the charge point ready for use the owner needs
to activate the charge point through our online portal
my.newmotion.com. The serial number of the charge
point is required for this process and can be found on the
right hand side of the charge point. Charge cards can be
activated in the same online portal.
6.2 REGULAR USE
The first step is to connect your car to the charge point
by plugging in the charge cable.
If you are using Plug&Charge the session will start
automatically.
If you have to identify first; swipe your charge card above
the LED.
The LED will flash green to authenticate the card and
after acceptance, the session will start. If the LED
flashes red, the session has not been accepted.
When the car has delayed charging configured, the LED
will remain green until charging can start between the
car and charge point.
Start charging? Plug in & identify
Stop charging? Identify & unplug
Full or waiting to charge
Plug in or identify
Charging
Not accepted
Error
Flashing green or multi colors: starting procedure or
software update procedure for charge point.
INSTRUCTION MANUAL – P16
0130NM02INT02