EIBENSTOCK EMF 125.2 Notice Originale page 20

When working with the machine, always hold it firmly with both hands
and provide for a secure stance.
For further safety instructions, please refer to the enclosure!
Before starting the machine check the correspondence between voltage and
frequency according to the data mentioned on the identification plate.
Voltage differences from + 6 % and – 10 % are allowed.
The wall chaser is made in protection class II.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
The tool is equipped with a start-up speed limiter to prevent that swift
automatic circuit breakers are unintentionally triggered.
Recommended minimum cross sections and maximum cable lengths
Mains voltage Cross section in sq. mm
1.5
110V
230V 50 m
Switching on and off
The wall chaser EMF 125.2 is equipped with a lock-off button against
unintentional witch-on.
Abb.1
Abb.2
Restarting Protection
The restarting protection feature prevents uncontrolled restarting of the
machine after an interruption in the power supply. To restart the operation,
switch the On/Off switch to the Off position and start the machine again.
Electrical Connection
-
Moment operation
Switching-on: Slide the trigger switch forwards and then
Switching-off: Release the trigger switch.
Continuous operation:
Switching-on: Switch the machine on as described above.
Switching-off: Push the trigger switch upwards and
2.5
40 m
80 m
push the trigger switchupwards.
Now slide the trigger switch forwards again
and release in the front position to lock the
trigger switch (continuous operation).
release.
20