Troubleshooting; Normal Operation - Danby DCR023C1W-MOL2 Guide D'utilisation Et Soins De Propriètaire

Troubleshooting

Occasionally, a minor problem may arise, and a service call may not be necessary- use this troubleshooting guide for a
possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll Free
Number for assistance.
NORMAL OPERATION
1 A flowing water sound: A flowing water sound will be heard under normal operation.
2 Outside condensation: Outside condensation is normal in very humid conditions. You may wipe the unit yourself.
3 It takes some time for the temperature of the freezer and refrigerator compartments to become cold after the
refrigerator starts operating. If the temperature of the two compartments is high while the refrigerator is operating, it
takes some time for the temperature of the two compartments to become cold. If the environmental temperature is
high, it takes a long time to make the compartments cold.
4 The surface of the compressor becomes hot: The surface of the compressor may become hot under normal
operation. Do not touch it with your hands.
PROBLEM
1) Does not work.
2) Refrigerator runs
continuously.
3) Internal temperature
not cold enough.
Tel: 1-800-26-DANBY (1-800-263-2629)
POSSIBLE CAUSE
• No power to unit.
• Power cord is unplugged.
• Wrong voltage is being used.
• Temperature control is set too high
(too cold).
• Door is not closed.
• Hot food inserted.
• Door opened too long or too often.
• Close proximity to heat source or
direct sunlight.
• No power to unit.
• Power cord is unplugged.
• Temperature control set too cold .
• Door is not closed.
• Hot food inserted.
• Door opened too long or too often.
• Air flow obstruction.
• Wrong voltage is being used.
• Close proximity to heat source or
direct sunlight.
• Check connection of power cord to
power source.
• Plug in unit.
• Use proper voltage.
• Set temperature control lower
(warmer).
• Close door securely.
• Be sure food is at room temperature
before inserting.
• Minimize door openings/duration.
• Do not place unit close to heat
sources or direct sunlight.
• Check connection of power cord to
power source.
• Plug in unit.
• Check setting and increase as need-
ed.
• Close door securely.
• Be sure that food is at room
temperature.
• Minimize door openings / duration.
• Allow room for air to circulate around
unit.
• Use proper voltage.
• Do not place unit close to heat
sources or direct sunlight.
9
SOLUTION