Preparatory Activities - Arbonia WKS Instructions D'utilisation Et De Montage

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Nominal voltage
Cable cross section
Maximum switching
capacity
Load rating of contact
Power consumption in
stand-by mode
Insulation type ther-
mostat
Protection type wall
outlet
Wireless standard
Bluetooth
Operating principle
Degree of soiling
Rated surge voltage
Protection type WKS
3.6 Protective areas in rooms with bath
or shower facilities (for installation
examples, see Fig. A)
W
According to national installation standards
(in Germany DIN VDE 0100-701), electrical
equipment may only be installed in specific
areas in rooms with bathtubs and shower
facilities.
W
Electrical equipment is permitted in the afo-
rementioned rooms if they are protected by
a residual current protective device (RCD)
(in Germany according to DIN EN 61008-1
(VDE 0664-10)).
W
Electric devices are to be installed so that
the switches and other control and/or regu-
lation equipment cannot be touched by a
person in the bathtub or the shower.
02/2019
230 V AC
2 x 1.5 mm²
1800 W
8 A / 250 V ~ at cos   = 1
or
2 A / 250 V ~ at cos   = 0.6
approx. 0.6 W
Protection class II
IPX4 after proper instal-
lation
BLE 4.2
Type 1.B.
2
4 kV
IP20
W
Sockets, switches, and control units (ther-
mostat WKS) may only be installed outside
the protective areas.
Note
The manufacturer does not permit installati-
on of products in safety area 1.
W
Only install the following products in safety
area 2 or outside the safety areas:
– Radiator with electric heating element
(observe DIN  55900 "Coatings for radi-
ators")
– Thermostat WKS
– Wall outlet IPX4

3.7 Preparatory activities

W
Ensure that an outlet socket is available wi-
thin the cable range of the electric heating
element.
W
Ensure that there is an additional outlet so-
cket with power supply (230 V, fuse B16 A)
at the location designated for using the
thermostat.
A line connection is necessary between the
two outlet sockets. To install device inserts,
it is advisable to use outlet sockets with an
installation depth ≥ 40 mm and diameter of
68 mm.
W
Install the radiator and electric heating
element if applicable.
Thermostat WKS
Installation
11

Publicité

Table des Matières
loading

Table des Matières